Authors
Brian Mason, Daniel Munden, Dawn Jegley, Ray Grenoble, Ramy Harik
Conference
Proceedings of the American Society for Composites—Thirty-fourth Technical Conference.
Abstract
For decades, composite wind tunnel blades have been constructed using labor-intensive hand layup processes. Automated Fiber Placement (AFP) is a relatively new technology that has not seen widespread use in manufacturing composite wind tunnel blades. AFP offers the potential for reduced manufacturing time, reduced cost, and improved consistency compared to traditional hand layup procedures. These manufacturing qualities are becoming increasingly important as existing wind tunnel blades are replaced due to impact damage or wear and tear from decades of use. Researchers at the NASA Langley Research Center are currently using the Integrated Structural Assembly of Advanced Composites (ISAAC) facility to investigate the feasibility of AFP for manufacturing composite wind tunnel blades. ISAAC uses manufacturing tools as surfaces on which to place fiber tows. A manufacturing tool was developed for using AFP to build a wind tunnel blade shape. This paper presents the structural design and analysis of this tool, for use with AFP, constructed from high temperature thermoplastics. The tool fabricated by this design process was successfully used for AFP and oven cure of two representative airfoil shaped composite structures.
Citation
Brian Mason, Daniel Munden, Dawn Jegley, Ray Grenoble, & Ramy Harik. (September 2019). Design and Analysis of a Tool for Automated Fiber Placement of Composite Wind Tunnel Blades. Proceedings of the American Society for Composites—Thirty-fourth Technical Conference. doi:10.12783/asc34/31303
Link: 10.12783/asc34/31303